ENGLISH / A-17
CONTROLS
FIGURE 24
SPRAY AND VAC WAND SWITCH (Optional)
The spray and vac wand switch (A) is located on the instrument panel as shown in fi gure 24. Pressing the bottom half of switch turns on the
vacuum motor and the solution pump. Pressing the top half of the switch turns the vacuum motor and solution pump off.
FIGURE 25
ESP SWITCH (Optional)
The ESP switch (B) is located on the instrument panel as shown in fi gure 25. The ESP switch transfers water from the recovery tank through a
fi lter and into the solution tank. When the switch is in the down position the pump will operate when the high recovery light is illuminated. Clean
the recovery tank when the tank is emptied.
NOTE
Do not place clean water in the recovery tank when using ESP option, the solution tank could become overfi lled during operation.
FORM NO. 56041720 - 7730 - A-17