The Cleaning Operation - American-Lincoln 56515851 Instrucciones De Uso

OPERATING INSTRUCTIONS
TO START MACHINE
Turn key to "I" position.
TO TRANSPORT MACHINE
1. Make sure the brushes and squeegees are in the up or raised position with all other controls in the off position.
2. Release the parking brake.
3. Push the forward/reverse switch to desired position (up for forward and down for reverse)
4. Push down on the foot throttle to obtain desired travel speed.
5. Release the foot throttle to slow down or stop when on a fl at surface. To slow the machine when decending down an inclined surface
reduce foot pedal pressure.
The pedal proportional braking sytem is designed to regulate machine speed according to the foot thottle position. This sytem is designed to bring
the machine to a stop in controlled manner. When driving down an inclined surface, reduce foot pedal pressure rather than releasing the foot throttle.
WARNING!
Do not turn the steering wheel sharply when the machine is in motion. The sweeper is very responsive to movement of the steering
wheel. Do not make sudden turns.
TO BEGIN THE CLEANING OPERATION
1. Select the operating mode
NORMAL = ESP
2. Lower brushes to the desired position.
SCRUB DECK = NORMAL RANGE OR HEAVY
3. Place the squeegee switch in the lower position.
SQUEEGEE BLADE = LOWER
4. Move solution control knob to the desired setting and begin operation.
SCRUBBING THE AVERAGE FLOOR WITH LIGHT TO MEDIUM SOILAGE
In this operation, cleaning is accomplished in one pass, with simultaneous solution feed, scrubbing and dirty water pick up. The rate of solution
feed and the speed of travel required will vary with fl oor condition. This knowledge will come with operator experience.
This will provide a controlled stop and prevent the drive wheel from locking.
NOTE
FIGURE 38
ENGLISH / A-23
FORM NO. 56041720 - 7730 - A-23