Technical Specifications; Warranty/Service - Beurer BY 15 Instrucciones De Uso

Problem
One of the breast pump components has be-
come altered or damaged.

11. Technical specifications

Model
Dimensions
Weight
Maximum suction pressure
Permissible operating conditions
Permissible storage conditions
Child use and care articles - Drinking equipment according to EN 14350
Device for expressing breast milk
Device with fine vacuum and low flow
Technical information is subject to change without notification to allow for updates.
The device complies with the Regulation (EU) 2017/745 of the European Parliament and of the Council
on medical devices, as well as the respective national provisions.

12. Warranty/service

Beurer GmbH, Söflinger Straße 218, 89077 Ulm, Germany (hereinafter referred to as "Beurer") provides
a warranty for this product, subject to the requirements below and to the extent described as follows.
The warranty conditions below shall not affect the seller's statutory warranty obligations which
ensue from the sales agreement with the buyer.
The warranty shall apply without prejudice to any mandatory statutory provisions on liability.
Beurer guarantees the perfect functionality and completeness of this product.
The worldwide warranty period is 3 years, commencing from the purchase of the new, unused product
from the seller.
The warranty only applies to products purchased by the buyer as a consumer and used exclusively for
personal purposes in the context of domestic use.
German law shall apply.
During the warranty period, should this product prove to be incomplete or defective in functionality in
accordance with the following provisions, Beurer shall carry out a repair or a replacement delivery free
of charge, in accordance with these warranty conditions.
If the buyer wishes to make a warranty claim, they should approach their local retailer in the first
instance: see the attached "International Service" list of service addresses.
Potential solutions
• Do not use any corrosive, gaseous cleaning agents or
solvents.
• In some cases, marked fluctuations in temperature can
damage the plastic on the breast pump.
• If any of the parts becomes damaged, stop using the
breast pump.
BY 15
approx. 9.1 x 15.5 x 21 cm
135 g
-0.32 bar
+5°C to +40°C; 30% to 85% relative humidity (non-con-
densing); 700 – 1060 hPa ambient pressure
-20°C to +60°C; 10% to 95% relative humidity (non-con-
densing); 700 – 1060 hPa ambient pressure
18