Configuration Of 01911 Programmable Chronothermostats; Configuration Of 01915 Thermostats - Vimar CLIMA 01923 Manual De Instrucciones

• To finish the procedure, press button C on the programmable
thermostat . In the case of the 01924 four channel actuator-re-
ceiver, repeat the procedure to configure the other channels .
4.CONFIGURATION
CHRONOTHERMOSTATS 01911.
• Replace the relay module in the timer-thermostat 01911 with the
radio-frequency transmitter module 01921 .1 .
• On the timer-thermostat, go to the SETTINGS menu and select
CONFIG . RF; the screen will show CONFIG . RF . Using the rotary
knob, select the desired channel (from 1 to 4) corresponding
to the relay you want to control (if using receiver 01923 always
select channel 1) . Press the
tion transmission phase commences .
• The transmission continues for 40 seconds, then the system
stops the procedure and goes back to the CONFIG RF menu
item . The transmission can be stopped manually by pressing the
selection button a second time .
• During the transmission, on the receiver 01923 or 01924 press
button P until the green LED blinks . Wait for channel program-
ming to be signalled by the red LED corresponding to this
channel blinking .
OF PROGRAMMABLE
selection button; the configura-
• To display the level of reception press button P until the green
LED goes out; the level is shown by the number of red LEDs
that light up:
- red LED 1: poor reception
- red LED 2: sufficient reception
- red LED 3: good reception
- red LED 4: optimum reception
Press button P until the green LED lights up again, to exit the
programming phase .
• If it has not yet ended automatically, stop the timer-thermostat
transmitting the configuration, press the
If using the 4-channel actuator 01924, repeat the procedure for
each of the channels you want to configure .

5. CONFIGURATION OF 01915 THERMOSTATS.

• Replace the relay unit installed in the 01915 thermostat with the
01921 .1 radio-frequency transmitter unit (for the replacement op-
eration, refer to the instruction booklet of the thermostat) .
• Check that the symbol appears on the thermostat display (wait
max . 2 minutes for automatic detection) .
}
green LED: off
selection button .
13 - ENGLISH