Reset Procedure; Characteristics - Vimar CLIMA 01923 Manual De Instrucciones

• Press the button (summer/winter menu)
• Press the button (radio configuration menu): a screen appears
displaying channel CH 0x . to select the desired channel (from 1
to 4) corresponding to the relay to be activated (select channel 1
for the 01923 . . . receiver) . Press the OK button: this initiates the
transmission configuration phase; it is signalled by a blinking cursor
and antenna icon .
• The transmission continues for about 2 minutes, after which normal
operation is automatically resumed .
• During transmission, on the 01923 or 01924 receiver, press the
button P until the green LED starts to blink . Wait until the channel
has been programmed, indicated by the blinking of the red led as-
sociated with that channel .
• To display the reception level, press the button P; the level is indi-
cated by the number of red LEDs which light up:
- red LED 1: poor reception
- red LED 2: adequate reception
- red LED 3: good reception
- red LED 4: excellent reception
Press the button P a second time to exit programming mode .
14 - ENGLISH
}
green LED: off
• To finish the procedure, press the OK button on the thermo-
stat . In the case of the 01924 four channel actuator-receiver,
repeat the procedure to configure the other channels .

6. RESET PROCEDURE.

Press and hold down the button P for 5 seconds; this will clear
all the values stored in memory . The operation is signalled by
the simultaneous blinking of all the red LEDs and the green LED .
7. PRINCIPAL CHARACTERISTICS.
• Supply voltage: 230 V~ ±10% 50-60 Hz
• Power consumption: 2 VA
• Output:
- 01923: 1 relay 6(2) A 250 V with clean changeover contact
- 01924: 4 relays 6(2) A 250 V with clean changeover contact
• Receiver: ASK 433 .92 MHz
• Sensitivity: -106 dBm approx .
• Usable antenna:
- 17 cm rigid wire antenna (not supplied) to be positioned verti-
cally and connected to terminal .