Aroma Function - WMF LINEO Instrucciones De Uso

Aroma function

You can activate the aroma function if you want to prepare a stronger, more
aromatic coffee. It is particularly recommended for preparing small quantities. To
do so, press the aroma button
start / stop button or before you activate the automatic switch-on system.
The symbol will be shown in the display until the preparation is complete.
Note: If you wait longer than approximately 5 seconds to start the brewing process
or activate the automatic switch-on system, the aroma function is deactivated
again.
Please note that the preparation time takes slightly longer.
Pre-brew function
(version with vacuum jug only)
In order to achieve a particularly intense flavour, you can activate the pre-brew
function . Only a small amount of water is advanced at first for the pre-brew.
After a brief pause, during which the coffee powder can swell, the brewing
continues. Press the button just before you start the brewing process with the
start / stop button or before you activate the automatic switch-on system.
The symbol will be shown in the display until the preparation is complete.
Note: If you wait longer than approximately 5 seconds to start the brewing process
or activate the automatic switch-on system, the pre-brew function is deactivated
again.
Please note that the preparation time takes slightly longer.
Automatic switch-on
If the preparation should start automatically at a programmed switch-on time,
briefly press the button and
The illuminated ring of the start / stop button illuminates with reduced brightness.
The preparation begins automatically at the programmed switch-on time and the
illuminated ring of the start / stop button illuminates with full brightness.
Note: As soon as the automatic switch-on time is confirmed, no other settings
can be made. In order to make changes, you must press the
deactivate the automatic switch-on.
You can cancel the preparation at any time by pressing the start / stop button.
Immediate start
Press the start / stop button briefly to prepare coffee immediately. The illuminated
ring illuminates with full brightness and the preparation begins.
You can cancel the preparation at any time by pressing the start / stop button.
Wait a few minutes until all of the coffee has run into the pot. Once the pot is
removed, a drip-stop valve prevents coffee from dripping out.
Automatic shutoff
(version with vacuum jug only)
After being powered on, an automatic shutoff ensures that the device does not
overheat. The device switches off only once all of the water has drained completely.
It is possible to shut off the device earlier by pressing the start / stop button. This
could be necessary if you accidentally switch on the unit without water. Before
filling the hot device with water, it is necessary to wait a few minutes to allow the
coffee machine to cool down.
just before you start the brewing process with the
will appear in the display.
button briefly to
13