Ce Conformity Declaration - Multiplex MULTIcont MSB EXPERT 20 Manual De Instrucciones

17. S U
OFTWARE PDATE
The firmware of MULTIcont MSB EXPERT speed controllers can
be updated using the free PC program "MPX-Launcher". You will
need to connect the controller's sensor connector to the USB PC-
receiver lead (UNI) (# 8 5149) to accomplish this.
18. T F
HE UNCTION OF THE
R B
THE ESET UTTON
The value for flight battery capacity can be reset using the speed
controller's RESET button (R) or RESET jumper. The value is not
reset automatically when the battery is disconnected, in order to
allow several flights to be carried out with a single battery.
If the controller is not directly accessible, i.e. if the Reset jumper
is inaccessible, then the RESET button (supplied as standard)
can be used to reset the battery capacity.
19. CE C
ONFORMITY
This device has been assessed in accordance with
the relevant harmonised European directives.
You are therefore the owner of a product whose design fulfils the
protective aims of the European Community relating to the safe
operation of equipment.
You are entitled to see the conformity declaration. Please ask
MULTIPLEX Modellsport GmbH & Co.KG for a copy.
20. D N
ISPOSAL OTES
Electrical equipment marked with the cancelled waste
bin symbol must not be discarded in the standard
household waste; instead it must be taken to a suitable
specialist disposal or recycling system.
In the countries of the EU (European Union), electrical
equipment must not be discarded via the normal
domestic refuse system (WEEE - Waste of Electrical and
Electronic Equipment, Directive 2002/96/EG). You can take un-
wanted equipment to your nearest local authority waste collection
point or recycling centre, where the staff will dispose of it correctly
and at no cost to yourself.
By returning your unwanted equipment you can make an
important contribution to
environment!
21. G / L
UARANTEE
Our products are covered by the currently valid statutory
guarantee regulations. If you wish to make a claim under
guarantee, please contact the model shop where you originally
purchased the unit.
The guarantee does not cover faults caused by:
•
Incorrect handling, incorrect connections, reversed po-larity
•
The use of accessories other than original MULTIPLEX items
•
Modifications or repairs not carried out by MULTIPLEX or by
an authorised MULTIPLEX Service Centre
•
Accidental or deliberate damage
•
Normal wear and tear
•
Use of the unit outside the stated Specification
MULTIPLEX Modellsport GmbH & Co.KG accepts no liability for
loss, damage or costs which are caused by the incorrect or
incompetent use of the product, or are con-nected with such use
in any way.
Operating Instructions
MSB EXPERT
RESET J
UMPER
D
ECLARATION
the protection of our
E
IABILITY XCLUSION
MULTIcont
20 / 40 / 60 / 80
/
shared
Seite 6 von 32