Description Of The Product; Fitting The Battery - EYENIMAL Bark Control Soft Manual De Instrucciones

Description of the product

White mark:
Area where the magnet is located to
switch On/Off or change mode

Fitting the battery

- Remove the screws from the battery cover with a screwdriver.
- Remove the battery cover.
- Insert the 3 Volt CR 2450 lithium battery as indicated under the battery holder (See diagram 2).
- A beep sound is emitted indicating that the battery was properly inserted. If you do not hear any
beep sound after inserting the battery, immediately remove it from the battery holder by using
the supplied magnet (magnetic key) or by tapping briefly the case in the palm of your hand.
- Check the polarity before inserting the battery once again. If you still do not hear any beep
sound, check the operation by switching the collar On and Off.
- Put the battery cover back in place taking care to insert first the little pin at the bottom of the
battery cover (See diagram 3).
- Retighten moderately the 2 screws.
Diagram 2
« + » terminal
of the battery
downward
Fitting the strap
- glide the strap alongside the case (See diagram 4)
- place the slide buckle on the strap
- attach the quick-snap buckle to the free edge of the strap
Nylon strap
Sensor
(short or long)
Gb - 12
Diagram 1
Diagram 3
Put the battery
cover back in
place taking care
to insert first the
little pin at the
bottom of the
battery cover