Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
USER'S GUIDE
• Package contents
a1 DELUXE STATIC NOBARK COLLAR fitted with a strap and short contact points
a1 Lithium 3-V CR2 battery
a1 magnetic key
a1 neon test lamp
a1 pair of long contact points
athis user's guide
• Description of the product
Diagram 1
Button for barking
detection sensitivity
adjustment
• Fitting the battery in the collar
Proceed as follows:
aUnscrew the battery cover using a coin.
aInsert the battery paying attention to follow polarity indicated under the collar ( (see. Diagram 1).
aRetighten the battery cover using a coin. A beep sound is emitted indicating the correct installation of the battery. If you
do not hear any beep sound when retightening the battery cover, remove the battery immediately from its housing.
Check the polarity before trying again.
• Activate/Deactivate the collar
aActivate: move the magnetic key towards the collar so that it comes into contact with the red mark, hold for 1 second
(See Diagram 3). A Beep sound will be emitted and the indicator light will flash in red indicating that the collar has been
switched on.
aDeactivate: move the magnetic key towards the collar so that it comes into contact with the red mark, hold for 1 second
(See Diagram 3). Three beep sounds will be emitted and the indicator light will go from flashing red to permanent red and
then off indicating the collar has been switched off.
U DELUXE STATIC NOBARK CONTROL indB.indd 3
U DELUXE STATIC NOBARK CONTROL indB.indd 3
Contact points
(short or long)
Bark detection
contact point
Indicator light :
On/Off indicator
+ battery level indicator
Red mark: magnet position indicator
This magnet allows to switch On/Off the collar
and to change operating mode.
Battery cover
Battery polarity indicator
WARNING
When inserting the battery, make sure to
follow polarity indicated on the collar
Diagram 2
3
11/05/2020 10:2
11/05/2020 10:2
Publicidad
Tabla de contenido
