Before Use; Switching The Appliance On; Operation - Hilti C 4/12-50 Manual De Instrucciones

5 Before use

5.1 Use the appliance only at a suitable location.
Use the appliance only indoors.
The location at which the appliance is used should be clean, dry and cool
but protected from frost.
Remove the charger from the toolbox before beginning charging.
Do not operate the charger inside a closed container.
5.2 Battery use and care
NOTE
Battery performance drops at low temperatures. Do not continue using the
battery until the tool comes to a standstill. Change to a second battery in
good time. Recharge the battery immediately so that it is ready for reuse.
Store the battery in a cool, dry place. Never store the battery where it is
exposed to the heat of the sun, on a radiator or behind glass, e.g. at a
window. Batteries that have reached the end of their life must be disposed
of safely and correctly to avoid environmental pollution.

5.3 Switching the appliance on

Plug the supply cord into the power outlet.

6 Operation

6.1 Inserting and charging the battery
CAUTION
Do not use the charger to charge other, unspecified batteries. A risk of
personal injury or fire and irreparable damage to the battery and charger
may otherwise result.
NOTE
Check that the contacts are clean and free from grease before inserting the
battery in the charger.
Push the battery into the battery interface.
Printed: 03.12.2015 | Doc-Nr: PUB / 5170386 / 000 / 01
2
en
21