Safety Instructions; General Safety Rules; Work Area Safety; Electrical Safety - Hilti C 4/12-50 Manual De Instrucciones

Voltage
10.8 V

4 Safety instructions

en

4.1 General safety rules

WARNING! Read all instructions! Failure to follow all instructions listed
below may result in electric shock, fire and/or serious injury. SAVE THESE
INSTRUCTIONS!

4.1.1 Work area safety

a) Keep work area clean and well lit . Cluttered and dark areas invite
accidents.
b) Do not operate the appliance in explosive atmospheres, such as
in the presence of flammable liquids, gases or dust. Chargers can
cause sparks which may ignite dust or fumes.
c) Keep children and other persons away from the area while the
charger is in use.

4.1.2 Electrical safety

a) The supply cord plug must match the outlet. Modification of the plug
in any way is not permissible. Unmodified plugs and corresponding
power outlets reduce the risk of electric shock.
b) Avoid body contact with earthed or grounded surfaces such as
pipes, radiators, ranges and refrigerators. There is an increased risk
of electric shock if your body is earthed or grounded.
c) Do not abuse the supply cord. Never use the supply cord to carry,
pull or unplug the appliance. Keep the cord away from heat, oil,
sharp edges or moving parts. Damaged or entangled cords increase
the risk of electric shock.
d) Only use the battery charger in areas which are dry. Water entering
an electric appliance increases the risk of electric shock.

4.1.3 Personal safety

Do not wear jewelry such as rings or chains. Jewelry could cause a short
circuit and personal injury in the form of burns.
18
Printed: 03.12.2015 | Doc-Nr: PUB / 5170386 / 000 / 01
Type
B 12/2.6 Li­Ion
Charging
times with the
C 4/12-50
34 min
For the follow-
ing tools (for
example)
SF 2­A