Grinding Wheels; Assembly And Adjustments - DeWalt D Serie Manual De Instrucciones

4-1/2" and 5" Grinding Wheels
Type 27 guard
Quick-change
backing flange
Type 27 depressed
center wheel
threaded clamp nut

ASSEMBLY AND ADJUSTMENTS

ATTACHING SIDE HANDLE
The side handle (E) can be fitted to either side of
the gear case in the threaded holes, as shown.
Before using the tool, check that the handle
is tightened se cure ly. Use a wrench to firmly
tighten the side handle.
Type 27 guard
Type 27 hubbed wheel
E
6

6" Grinding Wheels

Type 27 guard
stamped steel
Quick-Change
backing flange
Type 27 depressed
center wheel
threaded clamp nut
Rotating the Gear Case
WARNING: Turn off and unplug tool before making any
adjustments or removing or installing accessories. Before
reconnecting the tool, depress and release the trigger switch
to ensure that the tool is off.
1. Remove guard and flanges from tool.
2. Remove the four corner screws attaching the gear case to
motor housing.
3. Separating the gear case from motor housing not more than
1/4", rotate the gear case head to desired position.
Type 27 guard
Type 27 hubbed wheel