Grinding Wheels; Power Source - DeWalt D28490 Manual De Instrucciones

Grinding Wheels

mount
mount
type 27 guard
type 27 guard
wheel type 27
backing flange
mount
wheel type 27
guarda tipo 28
clamp nut
wheel type 28
NOTE: Wheel size must match guard size; i.e., a new 7" (180 mm)
wheel may not be used with a 9" (230 mm) guard. The bottom
surface of wheel must be inside the bend of the guard lip.
Attaching the Side Handle (Fig. 3)
To install the side handle, thread the
handle into one of the two positions and
mount
tighten securely by turning clockwise.
OPERATION
WARNING: Always observe the
safety instructions and applicable
regulations.
type 28 guard
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
backing flange
attachments or accessories. Before reconnecting the tool,
depress and release the trigger switch to ensure that the tool
is off. An accidental start-up can cause injury.

POWER SOURCE

Plug the large angle grinder into a dedicated electrical circuit.
wheel type 28
Operating this tool on a circuit with other tools will decrease tool
performance.
SWITCH (FIG. 4)
CAUTION: Before connecting the tool to a
power source or after a power failure, depress
clamp nut
and release the trigger switch (A) once without
depressing the lock-on button (B) to ensure
that the switch is in the off position. If the
trigger switch is locked on, the tool will start
unexpectedly when power is reconnected to
the tool. Hold the side handle and rear handle firmly to maintain
control of tool at start up and during use.
29
FIG. 3
FIG. 4
B
A