Maintenance; Planer Blades; Replacing The Planer Blades (Fig - Skil PL201201 Manual Del Propietário

MAINTENANCE

WARNING

Planer Blades

The planer blades have two cutting edges and may be reversed. When both cutting edges are
dull, the planer blade must be replaced.
The planer blades may not be re-sharpened. Do not attempt to sharpen or use re-sharpened
blades of any kind.
Use only blades designated for use with this model, because other blades will cause vibration,
decrease performance and may not clamp securely in the blade holder.

Replacing the Planer Blades (Fig .12)

WARNING
When installing blades, first disconnect the tool from the power supply, then clean out
•
all chips and/or foreign matter adhering to the blade holder and the clamping element .
Use blades of the same dimensions and weight, or else the holder will oscillate and
vibrate, causing poor planing action and tool breakdown .
Tighten the clamping screws carefully when attaching the blades to the planer . A
•
loose clamping screw could be extremely dangerous . Regularly check and ensure
that the clamping screws are securely tightened .
Be cautious when replacing the planer blades . Do not grasp the planer blades by the
•
cutting edges . Injury may result due to the sharp cutting edges of the planer blades .
To remove the old planer blades:
a. Disconnect the plug from the power source.
b. Place the planer upside down on a flat surface.
c. Loosen the three clamping screws with the wrench that is provided.
d. Push the blade sideways out of the blade holder. A piece of wood may be used for this
purpose.
To avoid accidents always disconnect the tool from the power supply
before cleaning or performing any maintenance .
15