Operating The Power Of This Unit Using The Remote Control Of Your Amplifier - Yamaha NS-SW901 Manual De Instrucciones

Operating the power of this unit using
the remote control of your amplifier
* This function is available only for Yamaha amplifiers
that meet the following conditions:
– The amplifier was released in 2005 or later.
– The remote control of the amplifier has two different
buttons for STANDBY and ON.
Note
When the AMP ID library code of the remote control has
been changed, this function may not work.
Rear panel
POWER
ON
OFF
POWER switch
POWER
ON
OFF
■Setting
1
Set POWER switch on the rear panel to the
OFF position.
2
Set switch to the ON position while
POWER
pressing and holding
on the front panel.
Continue holding down
switch for 3 seconds or longer.
After the STANDBY/ON indicator flashes 4 times, the
setting is completed.
Front panel
SUBWOOFER SYSTEM NS-SW901
1 2 3 1 2 3
STANDBY
PHASE B.A.S.S. PRESET
/ON
STANDBY
/ON
H-CUT VOLUME
STANDBY/ON switch
switch
STANDBY/ON
STANDBY/ON
SUBW
STANDBY
/ON
■Canceling
1
Set POWER switch on the rear panel to the
OFF position.
2
Set POWER switch to the ON position while
pressing and holding
on the front panel.
Continue holding down
switch for 3 seconds or longer.
After the STANDBY/ON indicator flashes 2 times, the
setting is completed.
Note
Place this unit within the operating range of the remote
control of the amplifier. If you place this unit far away from
the amplifier, you may not be able to operate this unit with
the remote control.
USING THIS UNIT
switch
STANDBY/ON
STANDBY/ON
SUBW
STANDBY
/ON
14
En