Manufacturer's Warranty - Hilti TE 800 Manual De Usario

Trouble or fault
The tool does not achieve full
power.
The chisel cannot be released
from the chuck.
9 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
10 RoHS (Restriction of Hazardous Substances)
Click on the link to go to the table of hazardous substances: qr.hilti.com/r3140904.
There is a link to the RoHS table, in the form of a QR code, at the end of this document.
11

Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
*2064795*
Printed: 08.07.2019 | Doc-Nr: PUB / 5200550 / 000 / 05
Possible cause
Power reduction is active.
The extension cord is too long or
its gauge is inadequate.
The voltage provided by the elec-
tric supply is too low.
The chuck is not pulled back fully.
2064795
Action to be taken
▶ Press the power level selector
switch (observe the power level
indicator). Switch the power
tool off and then on again.
▶ Use an extension cord with
an adequate conductor cross
section. (1.5 mm² for lengths up
to 40 m; 2.5 mm² for lengths up
to 65 m).
▶ Connect the power tool to a
different electric supply.
▶ Pull the chuck back as far
as it will go and remove the
accessory tool.
English 21