Active Vibration Reduction (Avr); Service Indicator; Power Level Indicator; Technical Data - Hilti TE 800 Manual De Usario

▶ Operation is permissible only when connected to a power source providing a voltage and frequency in
compliance with the information given on the type identification plate.
3.3

Active Vibration Reduction (AVR)

TE 800-AVR
The breaker is equipped with an Active Vibration Reduction (AVR) system, which greatly reduces vibration.
3.4

Service indicator

The breaker is equipped with a service indicator LED.
Status
The service indicator lights.
3.5

Power level indicator

The breaker is equipped with a power level indicator LED.
Status
The power level indicator lights.
3.6 Items supplied
Breaker, side handle, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group | USA: www.hilti.com
4

Technical data

4.1 Breaker
For details of the rated voltage, current, frequency and/or input power, please refer to the power tool's
country-specific type identification plate.
When powered by a generator or transformer, the generator or transformer's power output must be at least
twice the rated input power shown on the rating plate of the power tool. The operating voltage of the
transformer or generator must always be within +5% and -15% of the rated voltage of the power tool.
Rated power input
Single impact energy in accordance with EPTA proce-
dure 05
Weight in accordance with EPTA procedure 01
4.2 Noise information and vibration values in accordance with EN 60745
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure. The data given represents the main applications of the power tool.
However, if the power tool is used for different applications, with different accessory tools, or is poorly
maintained, the data can vary. This can significantly increase exposure over the total working period. An
accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This can significantly reduce exposure over the
total working period. Identify additional safety measures to protect the operator from the effects of noise
16 English
Printed: 08.07.2019 | Doc-Nr: PUB / 5200550 / 000 / 05
Meaning
End of service interval – servicing is due. Bring the
product to Hilti Service in good time. This will help
to ensure that it's always ready for use.
Meaning
Chiseling power is reduced to 70%. Press the
power level selector switch again to return to full
chiseling power. The chiseling power level can be
adjusted only when the tool is plugged in to the
electric supply.
TE 800
1,850 W
21 J
10.5 kg
2064795
*2064795*
TE 800­AVR
1,850 W
21 J
10.6 kg