Preparations At The Workplace - Hilti TE 800 Manual De Usario

and/or vibration, for example: Maintaining the power tool and accessory tools, keeping the hands warm,
organization of work patterns.
Noise information
Sound (power) level (L
Uncertainty for the sound power level (K
Emission sound pressure level (L
Uncertainty for the sound pressure level (K
Information about vibration
Chiseling (a )
h, Cheq
Uncertainty (K)
5 Operation
5.1

Preparations at the workplace

CAUTION
Risk of injury! Inadvertent starting of the product.
▶ Unplug the supply cord before making adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1.1 Fitting the side handle
CAUTION
Risk of injury! Loss of control over the breaker.
▶ Check that the side handle is fitted correctly and tightened securely.
▶ Fit the side handle.
5.1.2 Changing the accessory tool
WARNING
Risk of injury! The tool becomes hot as a result of use.
▶ Wear protective gloves when changing the tool.
1. Apply a little grease to the connection end of the accessory tool.
2. Push the accessory tool into the chuck as far as it will go (until it engages).
➥ The product is ready for use.
3. Pull the chuck back as far as it will go and remove the accessory tool.
Use only the recommended grease supplied by Hilti. Use of unsuitable grease may cause damage
to the product.
5.1.3 Removing the accessory tool
DANGER
Risk of fire! Risk of contact between the hot accessory tool and highly inflammable materials.
▶ Do not lay the hot accessory tool down on highly inflammable materials.
WARNING
Risk of injury! The tool becomes hot as a result of use.
▶ Wear protective gloves when changing the tool.
▶ Remove the accessory tool.
*2064795*
Printed: 08.07.2019 | Doc-Nr: PUB / 5200550 / 000 / 05
)
WA
)
WA
)
pA
)
pA
2
3
4
2064795
98 dB(A)
3 dB(A)
87 dB(A)
3 dB(A)
TE 800 TE 800­AVR
16 m/s² 8 m/s²
1.5 m/s² 1.5 m/s²
English 17