Strike Amp 8 Features - Alesis STRIKE AMP 12 Guia Del Usuario

Strike Amp 8 Features

Rear Panel
1. AC Input: Use the included power cable
to connect this input to a power outlet.
Make sure the Power Switch is set to
off when connecting or discon necting
the cable.
2. Fuse: If the unit's fuse is broken, lift this
tab to replace the fuse. Replace it with a
fuse with an appropriate rating (printed
under the unit's power cable input).
Using a fuse with an incorrect rating can
damage the unit and/or fuse.
3. Power Switch: Use this switch to power
the loudspeaker on or off. Make sure the
Volume knob is set to its minimum
(counterclockwise) position before turning
it on.
4. Power LED: This LED lights up when the
loudspeaker is on.
5. Volume: Turn each knob to adjust the
volume of each input.
6. Input: Use a standard XLR cable or 1/4"
(6.35 mm) TRS cable (not included) to
connect your audio source to this input.
7. Output: Use a standard XLR cable (not
included) to connect this output to the
input of another loudspeaker (i.e., another
Strike Amp).
8. Signal Limit LED: This LED lights up
green when an audio signal is sent to the
loudspeaker—it flashes at lower levels
and lights solidly at higher levels. The
LED lights
limit/protection is active—if the LED is lit
red continuously, reduce the volume of
your audio source.
9. Contour: Engage (depress) this button to
emphasize low and high frequencies by
+3 dB. Disengage (raise) the switch for a
flatter response for live performance or
for maximum output.
10. Ground Switch: Engage (depress) this
switch to reduce hum or noise.
8
up red when
5
6
1
output
5
9
4
8
6
3
2
10
7