Commissioning; Assemble Handle Fittings (Swp 475); Install Sliding Bracket - Stiga SWP 475 Manual De Instrucciones

Commissioning

6. Commissioning
6.1 Assemble handle fi ttings (SWP 475)
EN
Fig. 7: Handle fi tting assembly (SWP 475)
Two handle fi ttings (1) and the sliding bracket are
included as individual parts in the delivery.
1. Position the handle fi ttings (1) as shown in
Figure 7.
2. Insert the handle fi ttings in this position into
the intended receptacle (2) of the sweeper.
It may be necessary to slightly hit the handle
fi ttings in this step.
» Make sure that the handle fi ttings audibly click
into the device.
6.2 Install sliding bracket
CAUTION CAUTION
Risk of injury through tipping over of the Risk of injury through tipping over of the
sliding bracket! sliding bracket!
Tipping over of the sliding bracket may lead to Tipping over of the sliding bracket may lead to
slight injuries, such as jamming of the fi nger or slight injuries, such as jamming of the fi nger or
haematomas in users or other persons.
haematomas in users or other persons.
• When carrying the device, hold it so that the • When carrying the device, hold it so that the
sliding bracket cannot tip over. sliding bracket cannot tip over.
Sliding bracket for SWP 577
The sliding bracket can be adjusted to the height
of the user in two levels (A) and (B).
» (A): Lower level
» (B): Upper level
66
2
1
SWP 475 / 577
A
2
3
1
Fig. 8: Sliding bracket assembly
1. Turn the handles (1) into the vertical position.
2. Press the locking springs (3) inwards on both
sides of the sliding bracket.
3. Push the sliding bracket (2) into both handle
fi ttings simultaneously.
» To do so, the SWP 577 sliding bracket must
bent apart by about 10 cm before insertion in
the handle fi ttings.
4. Push the sliding bracket (2) into the handle
fi ttings until the locking springs lock in.
B
2
3
1