Tips And Advice On Installation; Questions About The Io Rgb Led Receiver - SOMFY RGB LED Receiver io Instrucciones

RGB LED Receiver io
The default setting is 6 hours.
To alter these settings, for each LED light:
1) Briefly press the my and Down buttons simultaneously on the
1W io control point.
2) Immediately afterwards, press and keep depressed the my and
Down buttons simultaneously until the LED light comes on
then goes out.
• Briefly press the Down button to set the period to 3 hours.
• Or briefly press the my button to set the period to 6 hours.
• Or briefly press the Up button to set the period to 12 hours.
The LED light comes on then goes out.
3) Press the my button until the LED light comes on then goes out.
The new setting is programmed.

2.3. TIPS AND ADVICE ON INSTALLATION

2.3.1. Questions about the io RGB LED receiver?
Observations
The LED light does not react at
all when a button is pressed on
the control point
The LED light comes on as
soon as the power is switched
on.
2.3.2. Replacing a lost or broken io control point
Reset to the original configuration (see 2.3.3.) and repeat the commissioning steps.
2.3.3. Restoring the original configuration
Attention
• Only perform the double cut-out on the io RGB LED receiver to be reset!
• This reset deletes all programmed control points.
Copyright © 2018 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
Possible causes
The control point has not been
programmed into the RGB LED
Receiver io.
The batteries in the control
point are low.
The control point used is
not compatible with the
RGB LED Receiver io.
The power supply is faulty.
The wiring is incorrect.
The wiring is incorrect.
0.5 s
< 2 s
= 3 h = 6 h
Solutions
Follow the commissioning
procedure (see 2.2.)
Replace the batteries, using the
same battery model.
Ensure the two products are
compatible.
Check the power supply.
Check the wiring (see 2.1.)
Check the wiring (see 2.1.)
EN
= 12 h
7