Use And Maintenance; Up And Down Buttons - SOMFY RGB LED Receiver io Instrucciones

EN
1) Cut the power supply for 4 s.
2) Switch the power supply back on for approximately 10 seconds
(for at least 5 seconds but no longer than 15 seconds).
3) Cut the power supply for 4 s.
4) Switch the mains power supply back on.
All the LED lights come on then go out.
5) Press the PROG button on the 1W io control point until all the
LED lights come on then go out twice.
The receiver is reset to its original configuration.
6) Repeat the commissioning procedures (see 2.3.).

3. USE AND MAINTENANCE

This product is maintenance-free.

3.1. UP AND DOWN BUTTONS

• To switch the LED light on:
- Briefly press the Up button.
• To switch the LED light off:
- Briefly press the Down button.
• To vary the colour of the coloured LED light:
- Press the Up or Down button and keep it depressed until
the desired coloured is reached.
͉
͉
If the button is kept depressed for more than 2 seconds, press the
my button to stop on the desired colour.
͉
͉
Keeping one of these buttons depressed has no effect for the white LED light.
8 Copyright © 2018 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
RGB LED Receiver io
OFF
4 s
5 s
ON
15 s
OFF
4 s
ON
< 0.5 s
< 0.5 s