Maytag Commercial MLE22PD Instrucciones De Instalación página 25

Replace the Door Assembly
1. Place the inner door assembly inside the outer door assembly.
2. Reassemble the inner and outer door assemblies with
the six screws.
Reverse the Strike
1. Use a small flat-blade screwdriver to remove the plug strip
from the dryer door opening. Slide the head of the screwdriver
under the plugs, without scratching the dryer surface, and lift up
the strip.
REVERSING DRYER DOOR SWING (OPTIONAL)
2. Remove the strike using a Phillips screwdriver.
3. Insert strike on the opposite side.
Reinstall the Door
1. Partially insert the third screw from the top; then slide the
hinge onto this screw while hooking the hinge into the front
panel hole. Reattach door to dryer front panel with the remaining
three screws.
2. Check for fingerprints on the glass. Clean if necessary.
3. Close door and check that it latches securely.
25