BIG ASS FANS Powerfoil X3.0 Guia De Instalacion página 21

B. Attach beam clamps and guy wires to mounting structure
Secure each beam clamp to the mounting structure at approximately
45° from the horizontal plane. Fully tighten the set screw to secure
the clamp. Fasten the small eyebolt and nut onto the clamp. The nut
will be on the outside of the clamp.
Loop the crimped end of each guy wire into a locking carabiner and
secure to each eyebolt. Securely tighten the carabiners. For best
results, the guy wires should be installed at 45° in the X-Y, Y-Z, and
X-Z planes. If the angle deviates by more than 15°, contact Customer
Service for assistance.
Guy Wire Hardware:
a. (4) 1/4-20 Beam Clamp
b. (4) 1/4-20 x 1" Eyebolt
c. (4) 1/4-20 Hex Nut
d. (4) Locking Carabiner
e. (4) Guy Wire
Side View (X-Y)
Guy
Wire
45°
C. Route guy wires through Gripples
Route each guy wire through a Gripple
the fan, and then back through the Gripple. Do not tighten the
Gripples until all guy wires have been installed.
To back a guy wire out of a Gripple, insert a 1/16" (2 mm)
Allen wrench into the small hole on the Gripple.
45°
and a carabiner on
®
WWW.BIGASSFANS.COM © 2018 DELTA T LLC
a
Top View (X-Z)
Guy
Wire
45°
45°
Gripple
ALL RIGHTS RESERVED.
b
d
c
e
45°
45°
17