Accessories; Warranty; Trouble Shooting - Dustcontrol DC 3800 Turbo EX Manual Original

Accessories

Description
Fine fi lter, polyester (Filter through
of cord potential off set)
HEPA fi lter
Suction hose 38, ESD-certifi ed
Suction hose 50, ESD-certifi ed
Coupling socket 50/50 ESD-certi-
fi ed

Warranty

Th e warranty period for this machine is two years and co-
vers manufacturers faults. Th e warranty is valid under the
condition that the machine is used under normal conditions
on the task for which it was designed and is maintained
properly. Normal wear is not covered by this warranty.

TROUBLE SHOOTING

Problem
Motor will not start.
*/ The motor protection should never be disconnected because the factory installation is to
protect against overheating.
2011-07-06
Description
Part no
Connecting sleeve 38/38 turnable
42398/429206
ESD-certifi ed
4422
Intermediate sleeve 50/38, ESD-
2012E
certifi ed
2013E
Floor nozzle 450 A-38 ESD-certi-
fi ed
2107E
Service performed by other thanDustcontrol or its aut-
horized agent voids automatically the warranty. No other
warranty express or implied is applicable
Fault
Machine not connected.
Motor protector tripped.
motor protection tripped
DC 3800/5800 Turbo EX - 14
Part no
2114E
2120E
7236E
Solution
Make sure connection.
Investigate why the motor has
loaded and attend. Note that if
the machine has been working
with too big a restriction, the
motor protector may have trip-
ped to protect against overhea-
ting. Wait 5 minutes. Reset by
fi rst turning to the 0 position
and then to the starting posi-
tion.
Part No 94125-D_94127-C