Briggs & Stratton Elite 3300 MAX PSI Manual Del Operador página 13

10. Move choke lever (A) to CHOKE (
A
NOTICE For a warm engine, be sure the choke lever
is in the RUN ( ) position.
WARNING Risk of eye injury.
Spray could splash back or propel objects
resulting in serious injury.
• Always wear indirect vented (chemical splash) safety
goggles marked to comply with ANSI Z87.1 when using
or in vicinity of this equipment.
• NEVER substitute safety glasses or dry-condition
goggles for indirect vented safety goggles.
NOTICE Before starting the pressure washer, be sure
you are wearing safety goggles as described below.
11A. For electric starting, turn and hold key in start
switch to start ( ) position until pressure washer
starts. To prolong the life of starter components,
DO NOT hold key in start ( ) position for more
than 5 seconds, and pause for at least 1 minute
between starting attempts.
• If engine starts, proceed to step 14.
• If engine fails to start, proceed to step 12.
NOTICE If battery is discharged, use manual starting
instructions.
11B. For manual starting, position yourself as
recommended below, grasp recoil handle and pull
slowly until you feel some resistance. Then pull
rapidly to start engine. Return starter grip handle
slowly. DO NOT let rope "snap back" against starter.
• If engine starts, proceed to step 14.
• If engine fails to start, proceed to step 12.
) position.
WARNING Starter cord kickback (rapid
bruises, or sprains resulting in serious injury.
• NEVER pull starter cord without first relieving spray gun
pressure.
• When starting engine, pull cord slowly until resistance is
felt and then pull rapidly to avoid kickback.
• After each starting attempt, where engine fails to run,
always point spray gun in safe direction, press red button
and squeeze spray gun trigger to release high pressure.
• Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury when spray gun kicks back.
NOTICE After each starting attempt, where engine
fails to run, always point gun in safe direction, press
red button and squeeze spray gun trigger to release
high pressure.
12. Move choke lever half way, pull recoil handle
twice or turn and hold key in start switch to
start ( ) position as described in step 11A.
•
13. If engine fails to start after six pulls, move choke
lever to RUN (
14. When engine starts, slowly move choke lever to
RUN (
falters, move choke lever to CHOKE (
position, then to RUN (
NOTICE Always keep the throttle control lever in the
FAST (
washer.
WARNING The high pressure stream of water
amputation.
Spray gun traps high water pressure, even when
engine is stopped and water is disconnected, which
could result in serious injury.
• DO NOT allow CHILDREN to operate pressure washer.
• Keep high pressure hose connected to pump and spray
gun while system is pressurized.
• NEVER aim spray gun at people, animals, or plants.
• DO NOT secure spray gun in open position.
• DO NOT leave spray gun unattended while machine is
running.
• NEVER use a spray gun which does not have a trigger
lock or trigger guard in place and in working order.
• Always be certain spray gun, nozzles and accessories
are correctly attached.
retraction) will pull hand and arm toward
engine faster than you can let go which
could cause broken bones, fractures,
If engine fails to start, repeat steps 10 thru 11.
) position, and repeat step 11.
) position, as engine warms. If engine
) position.
) position when operating the pressure
that this equipment produces could cut
through skin and its underlying tissues,
resulting in serious injury and possible
)
13