How To Stop Your Pressure Washer; How To Store Accessories; How To Use Spray Tips - Briggs & Stratton Elite 3300 MAX PSI Manual Del Operador

WARNING Exhaust heat/gases could ignite
combustibles, structures or damage
fuel tank causing a fire, resulting in
death or serious injury.
Contact with muffler area could cause burns
resulting in serious injury.
• DO NOT touch hot parts and AVOID hot exhaust gases.
• Allow equipment to cool before touching.
• Keep at least 5 ft. (1.5 m) of clearance on all sides of
pressure washer including overhead.
• It is a violation of California Public Resource Code,
Section 4442, to use or operate the engine on any forest-
covered, brush-covered, or grass-covered land unless
the exhaust system is equipped with a spark arrester, as
defined in Section 4442, maintained in effective working
order. Other states or federal jurisdictions may have
similar laws.
Contact the original equipment manufacturer, retailer,
or dealer to obtain a spark arrester designed for the
exhaust system installed on this engine.
• Replacement parts must be the same and installed in the
same position as the original parts.

How to Stop Your Pressure Washer

1. Release spray gun trigger and let engine idle for
two minutes.
2. Move throttle to SLOW (
STOP ( ) position.
3. Turn fuel valve to OFF (0) position.
WARNING The high pressure stream of water
that this equipment produces could cut
through skin and its underlying tissues,
resulting in serious injury and possible
amputation.
Spray gun traps high water pressure, even when
engine is stopped and water is disconnected, which
could result in serious injury.
• Keep high pressure hose connected to pump and spray
gun while system is pressurized.
• ALWAYS point spray gun in safe direction, press red
button and squeeze spray gun trigger to release high
pressure, every time you stop engine.

How to Store Accessories

The unit is equipped with multiple places to store your
spray gun, nozzle extension, high pressure hose and
spray tips.
Low
Pressure
Use to apply
detergent
Black
14
) position, then
White 40° Green 25°
1. Place spray gun into spray gun holder wireform as
shown.
2. Place nozzle extension into metal spring clips on
side of unit as shown.
3. Coil high pressure hose onto hose wrap.
4. Insert multi–colored spray tips in spaces provided
on side panel.

How to Use Spray Tips

The quick–connect on the nozzle extension allows you
to switch between five different quick connect spray
tips. Spray tips can be changed while pressure washer
is running once spray gun trigger lock is engaged. The
spray tips vary the spray pattern as shown.
Follow these instructions to change spray tips:
1. Pull back collar on quick–connect and pull current
spray tip off. Store spray tips in holder provided on
the side panel.
WARNING The high pressure stream of water
that this equipment produces could cut
through skin and its underlying tissues,
resulting in serious injury and possible
amputation.
• NEVER exchange spray tips without the trigger lock
being engaged on the spray gun.
• DO NOT twist spray tips while spraying.
2. Select desired spray tip:
• For gentle rinse, select white 40° or green 25°
spray tip.
• To scour surface, select yellow 15° or red 0° spray tip.
• To apply detergent, select black spray tip.
Yellow 15°
BRIGGSandSTRATTON.COM
High
Pressure
Red 0°