Install Wheel Kit; Moving Pressure Washer; Attach Negative Battery Cable - Briggs & Stratton Elite 3300 MAX PSI Manual Del Operador

Install Wheel Kit

NOTICE Wheel kit is not intended for over-the-road use.
Install the wheel kit as follows:
1. Lift corner of pressure washer and slide caster
wheels up into bottom of tubing on each
underside of pressure washer frame.
2. Using a 3/4" (19 mm) wrench, turn nut (A) under
collar of caster wheels to tighten.
A
3. Slide flat washer (B), wheel (C) and another flat
washer (B) over axle stud (D).
E
B
NOTICE Be sure to install wheel with raised hub inward.
4. Lift corner of pressure washer slightly and slide
axle stud through mounting bracket on pressure
washer frame.
5. Insert retaining pin (E) through hole on axle stud.
6. Repeat steps 3 through 5 to secure second wheel.

Moving Pressure Washer

The pressure washer is equipped with a handle
that locks into three different positions for your
convenience. With the handle in the upright position,
it makes it easy to push or pull your pressure washer
to the desired location. With the handle in the middle
position, you can tilt the pressure washer back. The
handle also folds down flat for storage.
1. Screw handle pin (F) into bracket on left side of
frame (viewing pressure washer from engine end).
F
2. Pull handle pin out and lift handle to desired
position.
3. Release handle pin and make sure latch (G) locks
into place.
4. Place lock levers on caster wheels in the OFF (0)
postion to unlock wheels and move pressure washer
to desired location.
NOTICE Always face pressure washer and push or
C
pull to desired location. When moving pressure washer
on an incline, always make sure you are uphill from
D
pressure washer.
5. Place lock levers on caster wheels in the ON (I)
postion to lock wheels and keep pressure washer
from moving.

Attach Negative Battery Cable

Your unit is equipped with electric start capability but
can be started manually. If you choose not to use the
electric start feature, you do not need to connect the
negative battery cable.
The sealed battery on the pressure washer is pre–
installed except for the negative (black) battery cable.
WARNING Battery posts, terminals and related
accessories contain lead and lead compounds -
chemicals known to the State of California to cause
cancer and reproductive harm. Wash hands after
handling.
To install:
1. Cut off tie wrap securing loose end of negative
(black) cable.
2. Using 8 mm wrenches, remove screw (H) and nut
(J) on negative battery terminal (—) (K).
3. Slide negative battery cable (L) over screw.
G
K
H
L
7