Assembly; Attach Accessory Holders; Unpack Pressure Washer - Briggs & Stratton Elite 3300 MAX PSI Manual Del Operador

Assembly

Read entire operator's manual before you
attempt to assemble or operate your new
pressure washer.
Your pressure washer requires some assembly and is
ready for use after it has been properly serviced with
the recommended oil and fuel.
If you have any problems with the assembly of your
pressure washer, please call the pressure washer
helpline at (800) 743-4115. If calling for assistance,
please have the model, revision, and serial number from
the identification label available.

Unpack Pressure Washer

1. Remove the parts bag, accessories, and inserts
included with pressure washer.
2. Open carton completely by cutting each corner
from top to bottom.
3. Ensure you have all included items prior to
assembly.
Items in the carton include:
• Main Unit
• High Pressure Hose
• Spray Gun
• Nozzle Extension with Quick Connect Fitting
• Hose Wrap
• Wheels (2)
• Caster Wheels (2)
• Oil Bottle
• Oil Funnel
• Spray Gun Holder Wireform
• Battery Float Charger
• Operator's Manual
• Owner's Registration Card
• Multi–Colored Spray Tips (5)
• Handle Pin
• Axle Studs (2)
• Retaining Pins (2)
• Washers (4)
• Keys (2)
• Metal Spring Clips (2)
• Plastic Knobs (1)
• Screws (5)
• Hex Key Wrench
To prepare your pressure washer for operation,
you will need to perform these tasks:
1. Fill out and send in registration card.
2. Attach hose wrap, metal spring clips, spray gun
holder wireform and handle pin to main unit.
3. Install wheel kit on main unit.
4. Add oil to engine crankcase.
5. Add fuel to fuel tank.
6. Connect high pressure hose to spray gun and
pump.
6
7. Connect water supply to pump.
8. Attach nozzle extension to spray gun.
9. Select/attach quick connect spray tip to nozzle
extension.

Attach Accessory Holders

All assembly instructions in this section will be viewing
from engine end of unit.
1. Place hose wrap (A) over holes (B) on end of
main unit. Using provided hex key wrench, attach
hose wrap with three screws (C). Tighten by hand.
A
C
2. Insert spray gun holder wireform (D) through holes
on right side of unit frame. Hold wireform in place
and attach a plastic knob (E) from inside of unit.
Tighten by hand.
E
3. Using provided hex key wrench, attach metal
spring clips (F) to left side frame of unit with
screws (G). Tighten by hand.
G
BRIGGSandSTRATTON.COM
B
D
F