SATA Filter 400 Instrucciones De Servicio página 291

<< Operating instructions SATA filter 400 >>
3. Complete SATA filter 464 by glueing in the threaded connection piece
[E] the insert [F] and the sleeve nut [G]
4. Screw on [2-2] SATA filter 464 [C]
5. Screw on [2-3] air outlet module [D]
8. Use
Use solvent-resistant, antistatic, undamaged, technically flawless com-
pressed air hoses with a continuous pressure resistance of minimum 10
bar, e.g. Art. No. 53090!
Information!
• Install compressed air connection G ¼ i or appropriate SATA quick
coupling G ¼ i (Art. No. 13599, not included in delivery) to ball valve
[1-6].
• To ensure regular filter maintenance, please attach the adhesive stick-
ers 'filter exchange ' [1-7], [1-11], [1-13] in their respective colours
(yellow = sintered filter [A], blue = fine filter [B], black = activated
charcoal filter [C]) to the filter housings [1-8], [1-12].
1. Connect suitable compressed air hose.
2. Turn the pressure adjustment knob [1-5] in counterclockwise direction
to the maximum; state = closed
3. Fully open ball valve [1-6]
4. Turn pressure adjustment knob [1-5] to the right until required pres-
sure is displayed on the pressure gauge [1-3].
5. Control pressure when operating the spray gun (trigger fully pulled)
and re-adjust, if necessary.
9. Function
9.1. Filter stage [A]:
The first filtering stage separates particles > 5 µ as well as condensed
water and oil. A sinter filter (Art. No. 22160) is integrated in the filter.
Information!
Sintered filter:
Danger! Notice!
US
XXVI.5