Cleaning; Group Head And Rubber Seal; Accessories - Profi Cook PC-ES 1109 Instrucciones De Servicio

9. To remove the last coarse air bubbles knock the
milk jug after frothing carefully on the tabletop (as
if you would set it down a bit hard). Swivel the milk
jug slightly around. This helps to mix the foam after
frothing. Now waste no time. Pour the frothed milk
slowly into the espresso.
10. Swivel the milk jug slightly around while pouring the
frothed milk slowly into the espresso.
NOTE:
• With a few artful movements you can draw de-
signs into the foam.
• Sprinkle cocoa powder or cinnamon to taste
on the foam.
WARNING:
• Before cleaning, always remove the mains plug and wait until the
device has cooled down.
• Do not immerse the device in water. Otherwise this might result in
an electric shock or fire.
• The steam nozzle is hot immediately after use!
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
Clean the casing with a slightly damp cloth without
detergents.

Group Head and Rubber Seal

Wipe group head and rubber seal with a damp cloth.
Use a soft nylon brush to remove stubborn residues.
Dry with a soft cloth.

Accessories

You can clean the filter holder, filter inserts, the drip
tray grid, drip tray, the measuring spoon, the water
tank, and the steam nozzle in a warm rinsing bath.
Use a soft nylon brush, if necessary. Rinse with clean
water. Dry all parts with a soft cloth.
CAUTION:
These parts are not dishwasher-safe. Heat and
aggressive detergents can cause distortion and
decolouration.
62
PC-ES1109_IM
11. IMPORTANT: Clean the steam nozzle immediately
after each foaming! The reason for this is that a
vacuum is generated in fractions of a second when
the rotary switch is closed, so that a little milk is
sucked into the steam nozzle. Set your heat-re-
sistant bowl under the steam nozzle. Momentarily
set the rotary switch again to the
short steam jet, so that the milk residue is flushed
from the steam nozzle.
12. Turn off the steam function by disengaging the
push-button switch in the

Cleaning

Water Tank
1. Open the lid to remove the water tank. Pull the tank
with both hands up and out. Replace the tank after
cleaning and drying.
NOTE:
The water tank has two hooks.
2. Hook the water tank into the two eyelets of the
appliance.
3. Press the water tank slightly down for the valve to
open.
Steam Nozzle
Clean the steam tube and the screwed-on steam noz-
zle immediately after each preparation of milk foam.
Dry milk residue is difficult to clean.
1. Unscrew the steam nozzle. Leave it for some time
in the warm rinsing bath. In this way milk residue is
easily removed.
2. Wipe the steam nozzle on the appliance with a
damp cloth.
position for a
position.
21.04.16