Cleaning And Maintenance; Technical Specifications - HQ-Power VDL8LS Manual Del Usuario

1 Truss
• Locate the short bar (±19cm/7.3"; without pre-drilled holes) and two T-joints (without
safety pin) and attach them together as indicated.
• Connect the two trusses as indicated and secure them in the T-joints with the butterfly
nuts.
Note: the system can also be used with only a single truss between the two side bars. In this
case, skip step 1.
2 Side bar
• Locate an 80cm/31.5" top bar and insert a short bar (±19cm/7.3"; with pre-drilled holes).
Align the holes and secure the connection with a bolt and wing nut. Place a washer on
either side of the bar.
• Slide the whole into the 165cm/64" bottom bar, align the holes and secure the connection
with a bolt and wing nut. Place a washer on either side of the bar.
• Secure the butterfly nut for additional strength.
• Slide two T-joints (with safety pin) over the top bar. Do not secure them yet.
• Repeat above procedure to assemble the second side bar.
Tripod
3
• Open a tripod and secure it with the butterfly nut.
• Slide the bottom part (with pre-drilled holes) of a side bar (see [2]) in the tripod.
• Determine the desired height. Insert a safety pin through the applicable pre-drilled hole.
The safety pin will rest on the tripod (see illustration).
• Secure the butterfly nut of the tripod.
• Repeat the above procedure for the other side.
4 Mount truss
This step should be performed by two adult persons.
• Insert the truss (see [1]) simultaneously into the two T-joints of the side bars.
• Insert the safety pin through the T-joints and secure the butterfly nuts of the trusses.
• Determine the desired height, make sure the truss is level and secure the butterfly nuts on
the side bars.
5 T-bar
• Place a T-bar on top of each side bar. Rotate it in the desired angle and secure it with the
butterfly nut.
• Use the included bolts to attach devices (not incl.) to the T-bars.

6. Cleaning and maintenance

• All screws should be tightened and free of corrosion.
• The device should not be deformed, modified or tampered with e.g. do not drill extra holes in
mounting supports, do not change the location of the connections ...
• Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.

7. Technical specifications

colour
max. Load
max. Height
width
weight
Use this device with original accessories only. Velleman nv cannot be held responsible in
the event of damage or injury resulted from (incorrect) use of this device.
For more info concerning this product, please visit our website www.hqpower.eu.
The information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved.
No part of this manual or may be copied, reproduced, translated or reduced to any electronic medium or otherwise without
the prior written consent of the copyright holder.
12.11.2009
VDL8LS
black
80kg (175lbs)
2.75m (9ft)
1.53m (5ft) or 3.05m (10ft)
24kg (53lbs)
6
©Velleman nv