Cleaning; Storage; Troubleshooting - Proficook PC-MCM 1024 Instrucciones De Servicio

Cleaning

WARNING:
• Before cleaning always disconnect from mains
power supply.
• Under no circumstances should you immerse
the device in water for cleaning purposes.
Otherwise this might result in an electric shock
or fire.
• The mixer blades are sharp! Risk of injury!
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
• The mixing jug is not dishwasher safe.
• Do not rinse the mixing jug in a bowl of water
either. The base of the mixing jug contains
electronic components that must not get wet!
• Should water however penetrate the base of
the mixing jug, allow to dry completely before
you use it again.
For cleaning the outside of the machine use only a
damp washing-up cloth.
Mixing jug
1. Fill the mixing jug with about 1 liter water by
adding a few drops of dishwashing liquid.
CAUTION:
Water with dishwashing liquid will foam up dur-
ing heating and mixing.
2. Heat up the water for about 8 minutes at cook-
ing setting HIGH.
3. Press the PULSE button briefly.
4. Allow the water to cool before cleaning the
inside wall of the mixing jug.
5. Clean the mixing jug from the inside with the
cleaning brush provided.
6. Rinse off the mixing jug with clean water and
carefully dry it off.
Lid and cap
1. Clean these components in a rinsing bath.
2. Rinse with clean water.
3. Dry the parts off.

Storage

• Clean the device as described. Let the acces-
sories dry completely.
• We recommend that you store the device in its
original packaging when it is not to be used for a
longer period.
• Always store the device at a well ventilated and
dry place outside the reach of children.

Troubleshooting

Mal-
Possible cause
function
The The device is
device not supplied
does not with power.
function.
The safety
switch is not
closed.
The device is
defective.
Liquids You have too
are not much or too
mixed cor- little liquid in the
rectly. vessel.
The speed is
too high.
The The selected
blades speed is too
become low.
blocked
after turn-
ing on.
Remedy
Check the outlet
with a different
device
Insert the power
plug correctly.
Check your
domestic fuse.
Check that the
mixing jug and
the lid are fitted
correctly.
Contact our
Service or a
specialist.
Vary the quantity
of the liquid.
Start with a lower
speed which you
can increase
later.
Start at a higher
speed.
65