Foppapedretti MEETING Manual De Instrucciones página 16

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 29
4
• ENGLISH •
ASSEMBLY
REMOVING THE INNER TRAY (8)
To remove the inner tray (8) pull the clips on the sides and lift it up.
The inner tray is fixed to the main tray using a pressure mechanism. To attach the inner tray,
place it on top of the main tray and press downwards; the securing clips will lock the inner
tray to the main tray.
CAUTION: Always make sure that the inner tray is correctly clipped to the main tray, before
each use.
STORING THE TRAY (9)
When not in use, the tray can be attached to the rear of the frame using the two hooks
(Fig.9).
Remove the tray from the seat and position it as shown in the figure. Align and insert the
attachment pins on the leg frame into the attachment guides located on the underneath
of the tray itself.
Press downwards to attach the tray to the frame.
To remove the tray from the frame, lift it upwards.
SAFETY HARNESS (10)
11
CAUTION: Using a safety harness with leg separator is essential to ensure
your child's safety.
CAUTION: The tray alone being attached to the seat does not guarantee that
your child is secured. Always use the safety harness!
The HIGH CHAIR is equipped with a 5-point safety harness.
• Unclipping the buckle: Press the button (a) and pull out the components (b).
• Clip the buckle: Insert the components (b) into the buckle (a); you will hear a
click when they are attached correctly.
Adjust the harness depending on the size of the child, using the adjusters (c).
Adjust the position of the straps, or chest belts, depending on the height of the
child. The straps must be adjusted in the slots close to the child's shoulders.
• To adjust the straps or to remove the safety harness, rotate the plastic
locking ring of the safety harness "straps" and "lap belt" on the rear side of
the backrest (d), and remove the harness by pulling it from the inner side of the
seat, through the slots in the seat shell and padding.
• To refit the straps,insert the plastic ring, fixed to the end of the strap,
through the slots in the fabric and the corresponding slots in the seat shell.
Rotate the ring into a vertical position, on the outer side of the backrest (e).
Make sure that it is correctly mounted and locked. When pulling the straps
from the inner side of the seat, the belts should not disengage.
Always make sure that the straps are positioned in the backrest slots located
at the same height.
IMPORTANT: The harness must only be used with all the components
attached.
IMPORTANT: Adjust the harness correctly each time the HIGH CHAIR is used.
16
12

Publicidad

Tabla de contenido
loading

Tabla de contenido