Makita TD022D Manual De Instrucciones página 7

Atornillador de impacto inalámbrico
Ocultar thumbs Ver también para TD022D:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

High tensile bolt
N•m
(ft•lbs)
20
(15)
15
(11)
2
10
(7)
5
(4)
0
1
1. Fastening time (second) 2. Fastening torque
3. Proper fastening torque corresponding to each bolt
diameter
Hold the tool firmly and place the point of the driver bit
in the screw head. Apply forward pressure to the tool to
the extent that the bit will not slip off the screw and turn
the tool on to start operation.
NOTICE:
If you use a spare battery to continue
the operation, rest the tool at least 15 min.
NOTE: Use the proper bit for the head of the screw/
bolt that you wish to use.
NOTE: When fastening M5 or smaller screw, carefully
adjust rotation angle on the switch so that the screw
is not damaged.
NOTE: Hold the tool pointed straight at the screw.
NOTE: If the impact force is too strong or you tighten
the screw for a time longer than shown in the figures,
the screw or the point of the driver bit may be over-
stressed, stripped, damaged, etc. Before starting your
job, always perform a test operation to determine the
proper fastening time for your screw.
The fastening torque is affected by a wide variety of
factors including the following. After fastening, always
check the torque with a torque wrench.
1.
When the battery cartridge is discharged almost
completely, voltage will drop and the fastening
torque will be reduced.
2.
Driver bit or socket bit
Failure to use the correct size driver bit or socket
bit will cause a reduction in the fastening torque.
3.
Bolt
Even though the torque coefficient and the
class of bolt are the same, the proper fasten-
ing torque will differ according to the diame-
ter of bolt.
Even though the diameters of bolts are the
same, the proper fastening torque will differ
according to the torque coefficient, the class
of bolt and the bolt length.
4.
The manner of holding the tool or the material of
driving position to be fastened will affect the torque.
5.
Operating the tool at low speed will cause a reduc-
tion in the fastening torque.
M6(1/4")
M6(1/4")
3
2
3
1
Using the tool as a hand screwdriver
Switch off the tool.
Move the lock lever to the locked position
Turn the tool.
NOTICE:
Use the tool with a fastening torque less
than 12.5 N•m.
NOTICE:
Do not use the tool for work requiring
excessive force, such as tightening bolt M10 or bolts
greater than M10 or removing rusted screws.
NOTE: This use is convenient for checking the
screwdriving.
Using holster
Optional accessory
CAUTION:
When using the holster, remove a
driver bit/drill bit from the tool.
CAUTION:
Turn off the tool and wait until it
comes to a complete stop before placing it in the
holster.
CAUTION:
Be sure to set the lock lever in the
locked position before using the holster.
CAUTION:
When using the holster, insert
the tool deeply and be sure that the tool is held
securely.
1.
Thread a waist belt or similar through holster
holder.
1
2
► 1. Holster holder 2. Waist belt
2.
Set the lock lever in the locked position and insert
the tool into the holster firmly.
7 ENGLISH
.

Publicidad

Tabla de contenido
loading

Tabla de contenido