Functional Description - Makita DA6300 Manual De Instrucciones

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.
Switch action
1
2
3
003019
CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and
returns to the "OFF" position when released.
Change the direction of rotation only when the tool
•
comes to a complete stop. Changing it before the
tool stops may damage the tool.
The switch is reversible, providing either clockwise or
counterclockwise rotation. To start the tool, simply pull
the lower part of the switch trigger for clockwise or the
upper part for counterclockwise. Release the switch
trigger to stop.
Speed change
003030
To change the speed, pull the pin and slide the button to
the "L" position for low speed or the "H" position for high
speed. If the button does not slide easily, turn the chuck
slightly in either direction while sliding the button.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
1. Counterclockwise
2. Switch trigger
3. Clockwise
1. Pin
2. Slide button
1
2
Spade grip
The spade grip can be installed in either of the positions
as shown in the figure. To change the location of the
spade grip from one position to the other, loosen the hex
bolts with a wrench and turn the spade grip to another
position. Then tighten the hex bolts securely.
1
2
003038
003039
Installing or removing drill bit
003051
To install the bit, place it in the chuck as far as it will go.
Tighten the chuck by hand. Place the chuck key in each
of the three holes and tighten clockwise. Be sure to
tighten all three chuck holes evenly.
To remove the bit, turn the chuck key counterclockwise
in just one hole, then loosen the chuck by hand.
OPERATION
Holding tool
CAUTION:
This is a powerful tool. High torque is developed
•
and it is important that the tool should be securely
held and properly braced.
4
1. Spade grip
2. Hex. bolt
1. Chuck key
1