Mounting The Adapter Frame (Spx1200T Only); Attaching The Seal For The Cab Roof; Fitting The Unit In The Roof Hatch - Dometic COOLAIR RTX 1000 Instrucciones De Montaje

Installation
7.4

Mounting the adapter frame (SPX1200T only)

A
NOTICE!
Ensure that the surface where the seal between the unit and the adapter frame
is to be glued is clean (free of dust, oil, etc.).
➤ Apply a flexible, non-hardening butyl sealant (e.g. SikaLastomer-710) to the
circumferential groove in the adapter frame (fig. 7).
➤ Mount the adapter frame as shown (fig. 7).
7.5

Attaching the seal for the cab roof

A
NOTICE!
Ensure that the surface where the seal between the unit and the cab roof is to
be glued is clean (free of dust, oil, etc.).
➤ Glue the sealing strip to the cab roof (fig. 8 A).
Follow the contour of the roof hatch opening. The join between the ends of
the seal should be at the back.
➤ Apply a flexible, non-hardening butyl sealant (e.g. SikaLastomer-710) to the
join between the ends of the sealing strip and to the top edge of the sealing
strip (fig. 8 B).
7.6

Fitting the unit in the roof hatch

➤ Place the parking cooler centrally and facing forwards in the roof hatch
opening (fig. 9).
I
NOTE
Once the unit is in position on the vehicle roof, the seal should make contact all
the way round. Only then can a reliable seal be achieved.
➤ Position the fixing brackets underneath the cab roof (fig. 0).
When doing so, slide the fixing brackets between the cab roof (chassis) and
the roof lining.
A
NOTICE!
The fixing brackets must be positioned on a firm base since they will brace the
unit against the cab roof. The contact area of the fixing brackets must be at least
40 mm on all sides.
10
RTX1000/2000, SPX1200T
EN