Default Settings Of Parameter Sets - Mettler Toledo Cond Ind 7100 e Manual De Instrucciones

66

Default settings of parameter sets

Two complete parameter sets are stored in the EEPROM.
As delivered, the two sets are identical but can be edited.
The sensor data and "Clean/PSEt2" output are only edited in
parameter set 1, but are valid for both parameter sets.
Note:
Fill in your configuration data on the following pages.
Code. Parameter
o1. Sensor selection * InPro7200
o1. Process variable
o1. Conc solution
o1. 0/4-20 mA
o1. Characteristic
o1. Current start (LIN) 000.0 mS
o1. Current end (LIN)
o1. Current start (LOG) 0.1 mS
o1. Current end (LOG) 100 mS
o1. Filter time
o1. 22mA signal
o1. Hold behavior
o1. Fix current
o2. Unit °C / °F
o2. 0/4...20mA
o2. Current start
o2. Current end
o2. Filter time
o2. 22mA signal
o2. Hold behavior
o2. Fix current
tc. Temp compensation OFF
tc. Temp coefficient
AL. Sensocheck
AL. Alarm delay
AL. LED Hold
*) These parameters are only edited in parameter set 1.
Cond Ind 7100 e
Default setting Code. Parameter
rL. Relay function
000.0 mS
L1. Contact function
-01-
L1. Contact response
4-20 mA
L1. Switching point
LIN
L1. Hysteresis
L1. Delay
100.0 mS
L2. Contact function
L2. Contact response
L2. Switching point
0 s
L2. Hysteresis
OFF
L2. Delay
Last
Ct. Setpoint
021.0 mA
Ct. Neutral zone
°C
Ct. P action
4-20 mA
Ct. I action
000.0 °C
Ct. D action
100.0 °C
Ct. PLC/PFC controller PLC
0 s
Ct. Pulse length
OFF
Ct. Pulse frequency
Last
Ct. Hold behavior
021.0 mA
Cn. Rinse/PSEt2 *
Cn. Rinsing interval *
02.00%/K
Cn. Rinse duration *
OFF
Cn. Contact response* N/O
0010 s
OFF
They are valid for both parameter sets.
Default setting
Limit
Lo
N/O
000.0 mS
001.0 mS
0010 s
Hi
N/O
100.0 mS
001.0 mS
0010 s
050.0 mS
001.0 mS
0100 %
0000 s
0000 s
0010 s
0060 /min
Last
rinse
000.0 h
0060 s
67