Siemens TSi80 Serie Instrucciones De Uso página 33

Problem
The motor does
not work.
Smoke comes out
when connecting
the iron for the first
time.
Deposits come out
through the holes
in the soleplate
(12).
The appliance
makes a pumping
sound.
The automatic
clean warning
lamp "calc" (4)
flashes.
If none of the above solves the problem, get in touch
with an Authorised Technical Service.
Probable cause
1. The iron is not in a
horizontal position.
2. The soleplate (12) is
heating up.
1. This may be caused by
the lubrication of some
of the internal parts.
1. Traces of lime scale are
coming out of the steam
chamber.
1. Water is being pumped
into the steam chamber.
1. "calc'n Clean" reminder
has been activated.
Solution
1. Use the iron in a
horizontal position.
2. Wait until the selected
temperature is reached.
1. This is normal and will
stop after a few minutes.
1. Carry out a cleaning
cycle (see "calc'n Clean
function" section).
1. This is normal.
1. Carry out a cleaning
cycle (see "calc'n Clean
function" section).
33
SIEM ENS