Troubleshooting - Siemens TSi80 Serie Instrucciones De Uso

Trouble shooting
Problem
The iron does not
heat up.
"startStop Control"
indicator lamp (2)
flashes.
Programme
indicator lamp (1)
flashes.
The clothes tend
to stick.
Water drips out of
the soleplate when
using the "shot of
steam" function.
Steam does not
come out in
horizontal position.
Excessive dripping
or steaming.
32
S I E ME NS
Probable cause
1. The "startStop Control"
function has been
activated. The iron is set
to stand-by.
1. The "startStop Control"
function has been
activated. The iron is set
to stand-by.
1. The soleplate (12) is
heating up or cooling
down to the selected
temperature.
1. The temperature of the
soleplate (12) is too
high.
1. You have pressed the
shot of steam button (7)
repeatedly without
waiting for 5 seconds
between each press.
2. The temperature is too
low.
1. "Steam on demand"
mode has been
selected.
1. No proper closing of
"clean" button (11).
Solution
1. Grip the handle of the
iron to re-start it.
1. Grip the handle of the
iron to re-start it.
1. This is normal and lights
will stop flashing when
the selected temperature
is reached.
1. Select a lower
temperature and wait
until the iron has cooled
down.
1. Wait 5 seconds between
each press of the shot of
steam button.
2. Set the temperature to
"max".
1. Press the steam
activation trigger (16) to
generate steam.
Double click on steam
activation trigger to
select the ""autoSteam"
mode.
1. Point the iron away from
the ironing area. Actuate
a few times the "clean"
button.