Hansa Harder & Steenbeck Airbrush 181 Instrucciones De Servicio página 11

Tabla de contenido

Publicidad

Troubleshooting ▪ Troubleshooting ▪ Troubleshooting
Luftblasen oder
„Blubbern" im Farb-
becher (D)
Air pockets or bub-
bling in the paint
cup (D)
Bulles d'air ou „gargouil-
lements" dans le godet à
peinture (D)
Gerät versprüht kein Farbe
a) Farbe nachfüllen
b) Nadelklemmmutter (K) prüfen und ggf. festziehen
c) Endstück (L) abschrauben,
Nadelklemmmutter (K) lösen, Hebel (F) herunterdrücken
(481/581/681) bzw. zurückziehen (181/281/381) und die
Nadel mehrmals vor und zurück bewegen. Danach Nadel
wieder ganz einschieben, Klemmmutter festdrehen und
Endstück aufschrauben
d) Düse und Nadel reinigen
e) ggf. verwendete Farbe verdünnen
Instrument does not spray any paint
a) Top up the paint
b) Check the needle securing nut (K) and tighten if
necessary
c) Unscrew the end piece (L), loosen the needle securing
nut (K), push the lever (F) downwards (481/581/681) or draw
it back (181/281/381) and move the needle forwards and
backwards several times. Push the needle in completely
again after this, tighten the securing nut and screw the end
piece into position
d) Clean the nozzle and needle
e) Thin the paint used if necessary
L'appareil ne pulvérise pas de produit
a) Remettre du produit
b) Vérifi er le contre-écrou de l'aiguille (K) et le cas échéant serrer à fond
c) Dévisser la queue (L), desserrer le contre écrou de l'aiguille (K), appuyer
sur la gâchette (F) (481/581/681) ou la tirer en arrière (181/281/381) et
exécuter à plusieurs reprises un va-et-vient de l'aiguille. Ensuite introduire
de nouveau l'aiguille à fond, serrer fermement le contre-écrou de l'aiguille
et revisser la queue
d) Nettoyer la buse et l'aiguille
e) Le cas échéant, diluer le produit utilisé
a) Luftkopf (B) fester anschrauben
b) Düse / Düsendichtung (C)
säubern
c) Düse / Düsendichtung (C)
auswechseln
a) Tighten the air head (B) more
fi rmly into position
b) Clean the nozzle/nozzle seal (C)
c) Replace the nozzle/nozzle
seal (C)
a) Visser la tête d'air (B) plus à fond
b) Nettoyer la buse/le joint d'étanchéité de
la buse (C)
c) Echanger la buse/le joint d'étanchéité
de la buse (C)
11

Publicidad

Tabla de contenido
loading

Productos relacionados para Hansa Harder & Steenbeck Airbrush 181

Tabla de contenido