Using The Appliance - Profi Care PC-BS 3039 Manual De Instrucciones

• Crevice nozzle:
For vacuuming dirt from corners, joints and small gaps.
• Brush nozzle:
For removing dirt gently from slits in upholstery and mat-
tresses. Also suitable for removing dust from sensitive
surfaces such as furniture or curtains.
Telescopic Suction Pipe (17)
The length of the telescopic suction pipe can be adjusted
individually:
1. Loosen the locking mechanism by
sliding and holding the button in the
direction of the arrow marking.
2. Extract one tube from the other to the
desired length.
3. Release the button in order to lock the
connection.
Mains Cable
Pull the mains cable from the cable compartment. The cable
compartment is located at the back of the appliance below.
CAUTION:
• Pull out the cable up to the maximum length indicated
with the yellow mark.
• Never pull the cable out up to the red mark as the
cable winding can be damaged.
NOTE:
If the red mark is visible, pull in the cable with the help of
the cable winding button back to the yellow mark.
Electrical Connection
• Before connecting the plug to the wall socket, check
whether the mains voltage is correct. Refer to the infor-
mation on the rating plate of the appliance.
• Connect the appliance to a certified wall socket only.

Using the Appliance

1. Insert the mains plug into a correctly installed power
socket.
2. Turn the appliance on by the on / off switch by pressing
down the button.
3. Set the "carpet / hard floor" switch, depending on the floor
covering.
4. Adjust the suction power with the suction power control.
5. Vacuum at a steady speed. There is no need to exert
pressure.
NOTE:
Pay attention to the range that can be covered with the
cable length!
32
PC-BS3039_IM
Air Slide
Open the air slide on the hose handle in
order to regulate the airflow or to clear any
particles sticking to the nozzle.
Switching Off and Winding Up the Mains Cable
1. Turn the vacuum cleaner off by the on / off switch and
remove the plug from the socket.
2. Keep the plug in your hand.
3. Press the cable winding button and guide the cable. Hold
the cable to avoid wrapping.
Maintenance
Emptying the Dust Collector
Empty the dust collector once the collected dirt reaches the
MAX marking.
1. Disconnect the mains plug from the wall socket.
2. Disconnect the hose from the hose connection.
3. Press the button (7) to release the dust collector. Re-
move the dust collector.
4. Empty the dust collector over a dustbin. To do this, pull
the latch on the dust collector to open the base plate.
5. Then close the base plate again.
6. Attach the dust collector to the appliance. First position
it at the bottom of the appliance and then secure it with
the hook on top.
7. Check that the position of the dust collector is secure by
briefly lifting the appliance at its carrying handle.
Filters
Your appliance features 4 filters. The common dust bag
system has been replaced by a transparent dust collector.
The higher flow speed of the collector allows for heavy dirt
and smallest floating particles to be separated from the
"sucked-in air".
It is thus not necessary to buy dust bags.
The filters must be cleaned regularly.
Filter Insert
CAUTION:
• Never wash the filter in the washing machine.
• Do not use a hairdryer for drying.
• Only use the appliance after the filters have been
installed correctly.
Proceed as follows to remove, clean and reinstall the filter
insert:
1. Empty the dust collector as described previously.
2. Remove the dust collector lid. Turn it anticlockwise in the
direction of .
14.05.19