Repairs; Transportation; Available Accessories; Environmental Protection - Elektra Beckum TKHS 315 C Manual De Uso

11. Repairs

A
Danger!
Repairs to electric tools must
be carried out by qualified electri-
cians only!
Electric tools in need of repair can be
sent to the service centre of your coun-
try. Refer to the spare parts list for the
address.
Please attach a description of the fault to
the electric tool.

12. Transportation

Lower saw blade fully.
Dismount add-on parts (fence, slid-
ing carriage, table extension).
If possible use original carton for
shipping.

13. Available accessories

For special tasks the following accesso-
ries are available at your specialized
dealer – see back cover for illustrations:
A Table Extension
For safe working of long stock.
B Sliding Carriage
For convenient guiding of long
stock.
C Suction Adapter
To connect a shop vacuum to the
dust collection attachment.
D Care and Maintenance Spray
To remove resin residue and pre-
serve metal surfaces.
E Saw blade HW 315 x 3.6 x 30
24 alternate bevel teeth
General purpose blade for rip and
cross cuts, also in particle board
(standard delivery).
F Saw blade CV 315 x 1.8 x 30
56 multiple combination teeth
for solid wood and particle board.
G Saw blade CV 315 x 1.8 x 30
80 neutral multiple teeth
For especially smooth cuts in solid
wood and particle board.
H Saw blade TCT 315 x 2.8 x 30
48 universal alternate bevel teeth
For all woods and wood-derived
materials.
I Roller Stand RS 420
J Roller Stand RS 420 W
K Roller Stand RS 420 G

14. Environmental Protection

The machine's packing can be 100%
recycled.
Worn out power tools and accessories
contain considerable amounts of valua-
ble raw and rubber materials, which can
be recycled.
These instructions are printed on paper
produced with elemental chlorine-free
bleaching process.

15. Trouble Shooting

A
Danger!
Before carrying out any fault
service or maintenance work, always:
1. switch machine OFF;
2. unplug power cable;
3. wait for saw blade to come to
standstill.
Check that all safety devices are
operational again after each fault
service.
Motor does not run
Undervoltage relay tripped by power fail-
ure:
switch on again.
No mains voltage
Check cables, plug, outlet and
mains fuse.
Motor overheated, e.g. by a blunt saw
blade or chip build-up in the chip case:
remove cause for overheating, wait
for a few minutes, then start saw
again.
Motor supply voltage too low:
use a shorter extension cable or
extension cable with larger lead
cross section
2
( 1.5 mm ).
Have power supply checked by a
qualified electrician.
Loss of cutting performance
Saw blade blunt (possibly tempering
marks on blade body):
replace saw blade (see chapter
"Care and maintenance").
Saw dust build-up
No dust collector or dust collector of
insufficient capacity connected (see
"Dust collector" in chapter "Operation"):
connect dust collector, or
increase suction capacity.
Height adjustment mechanism of saw
blade working stiff
Spindle of height adjustment mechanism
gummy:
clean spindle and spray with Care
and Maintenance Spray (see chap-
ter "Care and maintenance").
ENGLISH
25