Wheel Assembly - TFK dot Instrucciones De Uso

OPERATING MANUAL

Wheel assembly

-(Pic.I) Push the rear wheels (1) in the hub and keep pushing the red
knob (2). Once the wheel is positioned completely inside of the hub,
release the knob (2) and check if the wheel is locked. To take of the
wheel again, push the red button (2) and pull the wheel out of the
hub.
-(Pic.II) Push the front wheels (3) in the hub, until they lock in with a
click. To take of the front wheels, release the red button, and pull the
wheels out of the hub. The front wheels can either be locked , when
sliding the knob (4) downwards, or moveable if the knob (4) is slid to
the upper position.
Frame set up
-( Pic III) Pull the telescopic hinge towards the back of the buggy until
it locks in position (5). With a click. Push now the silver buttons left
and right, and then pull both handles towards you until the handle
bar locks. Now push the security bar (Pic.IV,6) upwards until it locks in
place.
Frame folding
-(Pic.IV) Release the security bar (6), and then push both silver knobs
(7). Those knobs stay unlocked. There is no need to keep on pushing!
Now push the handle bar forward until it locks again. Afterwards
release the lock of the telescopic hinge ( Pic.III,5) and push it forward
until the buggy is fully folded.
-(Pic.V) Push the red knob (8) to release and take off the bumper
bar.