Cutting Equipment - Jonsered CC 2129 Manual De Instrucciones

GENERAL SAFETY PRECAUTIONS
For mufflers, it is very important that you
follow the instructions on checking, main-
taining, and servicing your machine.
Never use a machine that has a faulty
muffler.
Regularly check that the muffler is securely
attached to the machine.
CAUTION:
Mufflers fitted with cata-
lytic converters get very hot during use
and remain so for some time after stop-
ping. This also applies at idle speed. Con-
tact can result in burns to the skin. Re-
member the risk of fire!
WARNING:
The inside of the
muffler contain chemicals that may
be carcinogenic. Avoid contact
with these elements in the event of
a damaged muffler.
WARNING:
Engine exhaust
fumes contain carbon monoxide,
which can cause carbon monoxide
poisoning. DO NOT start or run the
machine indoors, or anywhere that
is poorly ventilated. The exhaust
fumes from the engine are hot and
may contain sparks which can start
a fire. Never start the machine in-
doors or near combustible material!
Blade retainer nut
A blade retainer nut is used to secure
some types of cutting attachment.
115158126 Rev. 8 5/15/12
When fitting, tighten the nut in the opposite
direction to the direction of rotation of the
cutting attachment. To remove it, undo the
nut in the same direction as the cutting at-
tachment rotates. (CAUTION! The nut has
a left- -hand thread.) Tighten the nut using
the socket spanner.
The nylon lining inside the locking nut must
not be so worn that you can turn it by
hand. The lining should offer a resistance
of at least 1.5 Nm. The nut should be re-
placed after it has been put on approx. 10
times.

Cutting equipment

This section describes how to choose and
maintain your cutting equipment in order to:
S Reduce the risk of blade thrust.
S Obtain maximum cutting performance.
S Extend the life of cutting equipment.
IMPORTANT!
Only use cutting attachments with the guards
we recommend! See the section on
"Technical data".
Refer to the instructions for the cutting attach-
ment to check the correct way to load the
trimmer line and the correct line diameter.
Keep the teeth of the blade correctly sharp-
ened! Follow our recommendations. Also re-
fer to the instructions on the blade packaging.
Maintain the correct blade setting! Follow our
instructions and use the recommended file
gauge.
WARNING:
Always stop the en-
gine before doing any work on the
cutting attachment. This continues
to rotate even after the throttle has
been released. Ensure that the
cutting attachment has stopped
completely and disconnect the
lead from the spark plug before
you start to work on it.
WARNING:
Using an incorrect
cutting attachment or an incorrect-
ly sharpened blade increases the
risk of blade thrust.
English--- 8