Maintenance; Cleaning Pad; Fan And Sensors - ECOVACS ROBOTICS WINBOT8 Manual De Instrucciones

Before performing cleaning and maintenance on WINBOT 8, move the Power Switch to the
o
" " position and unplug it from the receptacle.

4.1 Cleaning Pad

Turn the robot over and remove the Cleaning
Pad. Rinse the Cleaning Pad and allow it to dry
completely before re-attaching it to the robot.
*
Do NOT use a wet Cleaning Pad
on WINBOT 8 or it may slip on the
window.

4.2 Fan and Sensors

Fan
Turn the robot over and wipe any debris from
the Fan with the provided Finishing Cloth to
maintain suction.
Edge Detection Sensors
Turn the robot over and wipe the four Edge
Detection Sensors clean with the provided
Finishing Cloth to maintain their effectiveness.

4. Maintenance

Wheel Sensor
Turn the robot over and wipe the Wheel
Sensor with the provided Finishing Cloth to
maintain its effectiveness.
13
EN