Before Use; Installing (Replacing) Saw Chain - Hitachi CS 36DL Manual De Instrucciones

English
● If the battery charger does not work while
the battery is mounted correctly, it is
probable that the battery or charger is
malfunctioning. Take it to your authorized
Service Center.
● When the pilot lamp fl ickers rapidly in
red (at 0.2–second intervals), check for
and take out any foreign objects in the
charger's battery installation hole. If there
are no foreign objects, it is probable that
the battery or charger is malfunctioning.
Take it to your authorized Service Center.
● Since the built-in microcomputer takes
about 3 seconds to confi rm that the
battery and back pack power supply being
charged with UC36YRSL is taken out,
wait for a minimum of 3 seconds before
reinserting it to continue charging. If the
battery is reinserted within 3 seconds, the
battery and back pack power supply may
not be properly charged.

BEFORE USE

Check the work area to make sure that it is clear of
debris and clutter.
Clear the area of unnecessary personnel. Ensure
that lighting and ventilation is adequate.
INSTALLING (REPLACING) SAW
CHAIN
WARNING
● To prevent accidents, always switch the
unit off , and remove the storage battery.
● Don't use the saw chain or the guide
bar other than
"SPECIFICATIONS".
CAUTION
Wear gloves and be careful to avoid injury
with the saw chain.
NOTE
○ When removing the saw chain, remove
sawdust from the oil spout, oil hole, and guide
bar groove.
If sawdust accumulates, this may cause the
unit to fail.
○ Use the correct type of saw chain in
accordance with the specifi cations.
If you install the wrong type of guide bar, the
saw chain may come off and injury may occur.
16
those specifi ed
1. Removing the side cover (Fig. 3)
1 Rotate the knob once to loosen it.
2 Rotate the tension dial half a turn to loosen it.
3 Using the supplied hexagonal bar wrench,
loosen the bolt until there is no resistance.
4 Turn the knob and remove the side cover.
Side cover
Bolt
Hexagonal bar wrench
2. Removing the saw chain and guide bar (Fig. 4)
Remove the saw chain and guide bar in the
direction indicated by the arrow.
3. Engaging the new saw chain in the sprocket
(Figs. 5, 6)
Engage the saw chain at the guide bar tip with
attention to the direction of the saw chain, and
then properly engage the saw chain with the
sprocket.
in
Sprocket
Tension dial
Knob
Fig. 3
Saw chain
Guide bar
Fig. 4
Saw chain
Guide bar tip
Fig. 5
Blade direction
Fig. 6