About Remaining Battery Indicator; Cutting Procedures - Hitachi CS 36DL Manual De Instrucciones

English
ABOUT REMAINING BATTERY
INDICATOR
When pressing the remaining battery indicator
switch, the remaining battery indicator lamp lights
and the battery remaining power can be checked.
(Fig. 20) When releasing your fi nger from the
remaining battery indicator switch, the remaining
battery indicator lamp goes off . The Table 5 shows
the state of remaining battery indicator lamp and
the battery remaining power.
Table 5
State of lamp Battery Remaining Power
The battery remaining power is
enough.
The battery remaining power is
a half.
The battery remaining power is
nearly empty.
Re-charge the battery soonest
possible.
As the remaining
somewhat diff erently
temperature and battery characteristics, read it as
a reference.
Battery level indicator switch
Battery level indicator
NOTE
○ Do not give a strong shock to the switch panel
or break it. It may lead to a trouble.
○ To save the battery power consumption, the
remaining battery indicator lamp lights while
pressing the remaining battery indicator switch.
○ When using a back pack power supply
(BL36200), check the battery level on the
battery level display of the back pack power
battery.
For details, see the BL36200 instruction
manual.
20
battery indicator
depending on ambient
Fig. 20

CUTTING PROCEDURES

WARNING
● Prior to operation, ensure that chain brake
works.
● During use, grip the handle securely with
both hands.
● When cutting timber from the bottom,
ensure the saw chain does not impact with
the timber.
If the unit is pushed back, injury may
occur.
● During work breaks or after work, always
switch the unit off , and remove the storage
battery from the main body.
Always monitor the workplace and surrounding
area, ensure there are no objects which could
cause injuries, accidents or failure, and if any are
present, remove them in advance.
In particular, when establishing a foothold for
working, ensure there is no instability or any object
which could be tripped over.
When felling standing trees, always pay careful
shows
attention to the direction in which the tree will fall
or roll, and determine a safe evacuation area and
escape route for yourself in advance.
1 Ensuring the unit is switched off
If the storage battery is inserted while the
switch is unknowingly engaged, the unit may
unexpectedly start, which may result in an
accident.
2 Installing the storage battery (Fig. 1)
As shown in Fig. 1, push fi rmly until it clicks into
place.
3 Engaging the switch
Ensuring the saw chain is not in contact with
the timber, engage the switch, and start cutting
when the saw chain speed has increased.
CAUTION
● When switching the unit on, ensure the
saw chain does not contact with material
or anything else.
● During use, be careful to ensure the saw
chain does not contact with other material
or object. In particular, when you have
fi nished cutting, be careful to ensure it
does not touch the ground.
NOTE
Refi ll the oil tank early to prevent the unit
running out of oil.