Makita DCG180 Manual De Instrucciones página 7

Installing holder joint
For short holder (300ml(18.3cu.in)) and
long holder (600ml(36.6cu.in))
Attach the holder joint firmly along the tool, set the
plate, and fix them with screws tightly.
For big holder (800ml(48.8cu.in))
Attach the holder joint firmly along the tool, and fix them
with screws tightly.
To remove the holder joint, follow above procedure in
reverse.
NOTE:
• There are three types of holders (optional
accessory), short holder (300ml(18.3cu.in)),
long holder (600ml(36.6cu.in)), and big holder
(800ml(48.8cu.in)). Use appropriate holder joint
accordingly.
Installing rod and piston
For short holder (300ml(18.3cu.in))
A
For long holder (600ml(36.6cu.in))
A
B
C
A
7 ENGLISH
B C