Makita DCG180 Manual De Instrucciones página 9

Installing the cartridge into the long
holder (600ml(36.6cu.in) or big holder
(800ml(48.8cu.in))
1
► 1. Holder cap 2. Rod handle
Remove the holder cap from the holder.
Pull the rod handle backwards slowly until it stops.
1
► 1. Holder cap
Insert the cartridge into the holder.
Attach the holder cap. Make sure it is tightened firmly.
Push the rod gently until the piston touches the bottom
of the cartridge.
To remove the cartridge, remove the holder cap, then
take out the cartridge.
NOTICE:
• Always check the cartridge for puncture or dam-
age before installing. Do not use damaged car-
tridge, otherwise the tool may be damaged.
• When using a partially used cartridge, remove any
adhered material on the cartridge.
Installing film type pack
NOTICE:
• Make sure the piston B is attached to the rod. Do
not use other type of piston for film type pack.
• Film type pack can be installed in the long holder
(600ml(36.6cu.in)) only.
Remove the holder cap, the nozzle and the rubber ring
from the holder.
Pull the rod handle backwards slowly until it stops.
2
Cut off the tip of the film type pack.
Insert the film type pack into the holder.
► 1. Rubber ring 2. Nozzle 3. Holder cap
Attach the rubber ring, the nozzle and the holder cap.
Make sure holder cap is tightened firmly.
Push the rod gently until the piston touches the bottom
of the film type pack.
NOTE:
• Always check the film type pack for puncture or
damage before installing. Do not use damaged
pack, otherwise the tool may be damaged.
Direct filling
NOTICE:
• Make sure the piston C is attached to the rod. Do
not use other type of piston for direct filling.
• Direct filling can only be performed with the long
holder (600ml(36.6cu.in)).
Remove the holder cap, the nozzle and the rubber ring
from the holder.
Make sure the rod handle is placed at the most front
position.
Dip the mouth of the holder into the caulking material.
Pull the rod handle slowly until required amount of
caulking material is filled in the holder.
Attach the rubber ring, the nozzle and the holder cap.
Make sure holder cap is tightened firmly.
NOTICE:
• Clean the holder with appropriate solvent after
every day's work. Otherwise adhered caulking
material may cause tool breakage.
9 ENGLISH
2
3
1